Tools
-
-
Open the X-CTU Software.
-
The starting screen should show you a com port used by an XBee. Make sure the settings match the settings in the picture.
-
Go to the Modem Configuration tab.
-
Click on the Read button.
-
-
-
First modify the channel. This can be any number or letter. Make sure this channel is the same across all XBee's that you are using.
-
Next, modify the DL- Destination Address Low field to FFFF. This will make the XBee's broadcast the data.
-
Modify the MY-16-bit Source Address. This can be any 16 bit number, and make sure all beacons have different address's.
-
-
-
Scroll down to the Serial Interfacing section. Disable AP-API Enable.
-
Hit the Write button to program the XBee.
-
Almost done!
Finish Line